المساعد الشخصي الرقمي

مشاهدة النسخة كاملة : مشكلة في تسطيب النسخه والشاشه الزرقاءي



sirelmagic
21-02-2010, 16:51
المشكلة هي ان انا قمت بعمل فورمات للسي وبعدين هنزل نسخه جديدة ولكن في مشكلة عندما يصل الي ملحه نسخ الملفات الي في الاول يقولي انهلايستطيع نسخ الملفات ويعطيني اختيارات اما (ريتراي)او سكيب) (او كويت)
لو عملت ريتراي كذا مره .بيجيب الشاشه الزرقاء
stop:0x00000026
لو سمحتم لو حد يقدر يفدني ويقلي ايه حل الشكلة

LAITHKHRESHEH
21-02-2010, 18:10
جربت نسخة ويندوز ثانية ،؟؟

و ما هو نظام الفورمات الذي اخترته ؟
اخترت NTFS‏ ‏أم FAT

sirelmagic
21-02-2010, 19:00
جربت نسخة تانيه وثالثة كمان مفيش فيدة
وبالنسبه لنظام الفورمات جربت fat و ال ntfs

sirelmagic
22-02-2010, 01:30
up up

LAITHKHRESHEH
22-02-2010, 13:04
إذا انتظر أهل الخبرة يا أخي

Fu'ad
22-02-2010, 13:56
السّلام عليكم...
كنت سأقول لك أن تجّرب نسخة أخرى , و لكنّك قمت بهذه الخطوة , لذا تأكّد من الآتي :
1- قارئ الأقراص المدمجة ( لو تقم بتبديله من صديق لك للتجربة أفضل - و أتوقّع أن العطل منه )
2- كيبلات قارئ الأقراص المدمجة , و كيبلات القرص الصّلب أيضاً قم بتبديلها .

توقّعاتي في أنّ المشكلة لن تتعدّى هذه الحدود , و لكن لحين أن تجرّب و تعطينا النّتيجة , سننظر في حلول أخرى .
مع فائق الاحترام...

gouba
22-02-2010, 14:00
Error Message:
STOP: 0x00000026 (parameter, parameter, parameter, parameter) CDFS_FILE_SYSTEM
Explanation:

This is a Windows 2000 Executive character-mode STOP message. This indicates a CD-ROM file system problem.
User Action:

If this is the first time you have booted after installing new hardware, remove the hardware and boot again. Check the Microsoft Hardware Compatibility List to verify that the hardware and its drivers are compatible with Windows 2000. For information about the hardware, contact the supplier. If you are installing Windows 2000 for the first time, check the Windows 2000 system requirements, including the amount of RAM and disk space required to load the operating system. Also, check the Hardware Compatibility List to verify that the system can run Windows 2000. If Windows 2000 is loaded and no new hardware has been installed, reboot with recovery options set to create a dump file. If the message continues to appear, select the Last Known Good option when you reboot. If there is no Last Known Good configuration, try using the Emergency Repair Disk. If you do not have an Emergency Repair Disk, contact your technical support group.


جرب انك تغير السيدي وازل كل القطع الموصولة معاك قبل ما تسطب الوندوز لان المشكلة دية مشكلة فقد بيانات

ومشكلة عدم توافق مع القطع الموصولة في جهازك