المساعد الشخصي الرقمي

مشاهدة النسخة كاملة : الى خبراء الشبكات ضرورى ياجماعه



ahmed_elmelih
06-09-2011, 23:49
انا عاندى راوتر اساسى وير ليس بورت واحد وصلته بسويتش ومن السويتش وصلت بروتر اخر ويرليس (tp-link td-w8901g) وعايز استخدم الراوتر الثانى عشان اوزع نت وير لس لجهاز بعيد عنى


مش عارف اعمل ايه مع العلم انى وصلت كبل من السويتش الى الراوتر الثانى لكن الويرليس مش جايب نت مش عارف ليه

black007
07-09-2011, 02:44
علشان تعمل الى انت بتقول عليه ده لزم تخلى الروتر التانى الى انت موصله بالسوتش الى هو (tp-link td-w8901g) لازم تحوله من روتر الى اكسس بوينت علشان يوزع نت
وده الطريقه اتبع الشرح
الشرح بالانجليزى والترجمه تحته بالعربى

To Configure Your Router as an Access Point

Important: Do not connect the wireless router/access point to your network yet, as it may have the same IP address as the router that's now connected to the Internet.



مهم جداً
لا تعمل الآن على توصيل الرواتر إلى الشبكة ، بسبب إحتمالية أن يكون عنوان الرواتر مشابه لعنوان الإتصال بالإنترنت
If the wireless router/access point is in the default state with the Configuration Assistant running, disable it:
إذا كان إعدادت الراواتر في الحالة الإفتراضية، فأعمل على تعطيله:
1. Select Start > Run, and type https://www.routerlogin.com/CA_HiddenPage.htm

1. من Select Start إختار Run وألصق التالي فيه ثم إضغط Enter
2. Select Disable Configuration Assistant.

2. إختار Disable Configuration Assistant
3. If there's a cable on the wireless router/access point WAN port, it needs to be disconnected (permanently).

3. إذا كان مدخل Wan في الراوتر يوجد به كيبل فيجب أن تزيله (( يجب أن يبقى هذا المدخل فارغ بشكل دائم ))
4. Configure the wireless router/access point with a wired PC, as shown.
Image

4. طبق التوصيل كما هو مبين في الصورة التالية

https://kbserver.netgear.com/images/1496_diagram.gif
5. Change the IP address of the wireless router/access point.

5. أعمل على تغيير عنواون الراوتر.
6. Disable the DHCP server of the wireless router/access point. Only one DHCP server should be used on the network.

6. عطل خيار DHCP server من الراوتر ( يجب تعطيله لأنه لا يجوز أن يكون في مثل هذه الشبكة أكتر من DHCP server )
7. Connect a LAN port on the wireless router/access point to a LAN port on the router, as shown

7. وصل مدخل الشبكة المحلية الذي في الراوتر بمدخل الشبكة المحلية كما في الصورة أعلاه
8. Configure SSID on wireless router/access point and wireless PCs so that they are the same.

8. الآن تأكد أنك متصل بالشبكة (( لا تنسى أن تتأكد من إسم الشبكة ويفضل قبل الإتصال إعادة البحث عن الشبكات ثم الإتصال ))
Extra Considerations



إعتبارات وملاحظات إضافية مساعدة
1. Be careful not to use duplicate IPs within your network.



1. لا تستخدم عنوان مزدزج في نفس الشبكة.
2. The DHCP server used by the router that is not the wireless router/access point should not have the IP address of the wireless router/access point in its DHCP range of IP pool (to avoid accidentally giving out a duplicate IP address).

2. DHCP server يستخدم في الراوتر الرئيسي ( الذي يتصل مباشرة مع الإنترنت ) فقط. لكي لا يحدث تضارب في العناوين.
3. If the router that is not wireless router/access point is also wireless:

3. في حالة أن الراوتر ليس به خدمة التوزيع اللاسلكي:
* Separate the two devices to the edge of their wireless ranges, or else

* فصل الراوترين عن بعضهما عن طريق فصل حافة المجال لكل راوتر
* Use different SSIDs.

* سمي كل راوتر بإسم مختلف.
4. If the router with Internet access is also wireless, you should configure different wireless channels on each device. Use the non-overlapping wireless channels 1,6, and 11 to avoid wireless interference.

4. في حالة أن الراوترين بهما خدمة التوزيع اللاسلكي، يجب عليك تغيير إعدادات القناة بحيث يختلف أحدهما عن الآخر ، إستخدم القنوات الغير متداخلة 1,6 ، و 11 لمنع التشويش اللاسلكي

او تريح نفسك من الكلام ده كله وتشترى اكسس بوينت وتوصله مكان الروتر التانى وتريح نفسك
وانت ورحتك